Drain Saddle Installation; Tank Elbow Installation - Watts Premier WP-5 Installation, Operation And Maintanance Manual

Drain Saddle Installation - Part# 164016
Step 14 Gather the pieces of the drain saddle
Step 15 The small square black foam gasket with a circle cut out of the
middle must be applied to the inside of the drain saddle. Remove
sticky tape backing and stick to the drain saddle as shown.
Step 16 Drill a ¼" hole through the drain pipe at least 1 ½" above the nut
of the P-trap to allow for the removal of the P-trap if necessary.
Assemble the drain saddle around the drain pipe. Position the
drain saddle over the drilled hole in pipe. Insert screw driver
into the opening of the drain saddle and align with drilled hole
in drain pipe.
and securely on both sides of the drain saddle. Attach black
compression nut, but do not tighten at this time. The black tubing
will be installed later.
Caution: Do not over tighten the screws. It may crack the drain saddle.
Tank Elbow Installation - Part# 125032
Step 17 Wrap (7 to 12 turns) Teflon tape clockwise around the male pipe
threads (MPT) on the Stainless Steel fitting on top of the tank.
Note: Do not let the tape cover the opening.
Step 18 Thread the plastic elbow (supplied in the parts bag) onto the
stainless steel connection on the top of tank. Tighten using an
adjustable wrench. Do not over tighten as plastic could crack.
Caution: Do not Teflon tape the plastic elbow threads as this may
cause leaks.
Drain Saddle fits standard 1 ¼" – 1 ½" drain pipes
1 Black compression nut
1 Semicircle bracket with opening
2 Screws
1 Foam washer
2 Nuts for screws
1 Semicircle bracket
Using Philips screw driver tighten screws evenly
Page 10