Performance Data Sheet - Watts Premier Filter Pure UF3 Installation, Operation And Maintenance Manual

Performance Data Sheet

Model: Filter Pure UF3
GENERAL USE CONDITIONS:
1. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
2: Operating Temperature:
3: Operating Water Pressure:
4: Maximum flow Rate:
5: Rated Capacity:
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description
Stage 1: sediment:
Stage 2: Lead + VOC Block
Stage 3: UF Membrane
This system has been tested according to NSF/ANSI Standard 42 and 53 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53. Testing performed under
standard laboratory conditions, actual performance may vary.
Substance
ALACHLOR*
ATRAZINE*
BENZENE*
BROMODICHLOROMETHANE (TTHM)*
BROMOFORM (TTHM)*
CARBOFURAN (Furadan)*
CARBON TETRACHLORIDE*
CHLOROBENZENE (Monochlorobenzene)*
CHLOROFORM (TTHM)*
CRYPTOSPORIDIUM (see Cyst)
CYST
2, 4-D*
DBCP (see Dibromochloropropane)*
1,2-DCA (see 1,2-DICHLOROETHANE)*
1,1-DCE (see 1,1-DICHLOROETHYLENE)*
DIBROMOCHLOROMETHANE
(TTHM;Chlorodibromomethane)*
DIBROMOCHLOROPROPANE (DBCP)*
o-DICHLOROBENZENE (1,2 Dichlorobenzene)*
p-DICHLOROBENZENE (para-Dichlorobenzene)*
1,2-DICHLOROETHANE (1,2-DCA)*
1,1-DICHLOROETHYLENE (1,1-DCE)*
CIS-1,2-DICHLOROETHYLENE*
TRANS-1,2- DICHLOROETHYLENE*
1,2-DICHLOROPROPANE (Propylene Dichloride)*
CIS-1,3- DICHLOROPROPYLENE*
Watts Premier
8716 W Ludlow Drive Suite #1
Peoria, AZ 8538
Maximum 100° F (40.5° C)
Maximum 85 psi (5.98 kg/cm
0.50 gpm (1.89 lpm)
150 Gallons (570 liters)
Part Number
105311
105371
105321
Minimum 40° F (4.4° C)
2 ) Minimum 20 psi
Change Time Frame
6 Months
6 Months
12 Months
Influent Challenge
Percent
Concentration
Reduction
(mg/L unless noted)
>98% 0.05
>97% 0.1
>99% 0.081
>99.8% 0.300 +/- 0.30
>99.8% 0.300 +/- 0.30
>99% 0.19
98% 0.078
>99% 0.077
>99.8% 0.300 +/- 0.30
99.99% minimum 50,000/mL
99.99% minimum 50,000/mL
98% 0.110
>99% 0.052
95% 0.088
>99% 0.083
>99.8% 0.300 +/- 0.30
>99% 0.052
>99% 0.08
>98% 0.04
95% 0.088
>99% 0.083
>99% 0.17
>99% 0.086
>99% 0.08
>99% 0.079
Page 11
Maximum Permissible
Product Water
Concentration
0.001
0.003
0.001
0.015
0.015
0.001
0.0018
0.001
0.015
99.95%
99.95%
0.0017
0.00002
0.0048
0.001
0.015
0.00002
0.001
0.001
0.0048
0.001
0.0005
0.001
0.001
0.001