Page 1
Please read carefully before proceeding with installation. Failure to follow attached instructions or operating parameters may lead to the product’s failure. ****************************************************************************************** Save manual for future reference. Model ZRO-4 ZERO WASTE REVERSE OSMOSIS SYSTEM System Tested and certified by WQA System Tested and certified by NSF...
Page 2
Giardia. There may also be some local water issues in your area such as high levels of lead, radium and copper. This Watts Premier water treatment system has been designed and tested to provide you with high quality water for years to come. The following is a brief overview of the system.
Watts Premier supplies speciality filters (part number 107008) that can be used if copper tubing follows the Reverse Osmosis unit. Be sure to follow any state or local regulations during installation.
Installation of Faucet Caution: Porcelain sink surface material is extremely hard and may crack or chip. Use extreme caution when drilling. Watts recommends the use of a professional for this, and accepts no responsibility for damage resulting from the installation of the faucet. Plastic Step 1 Determine desired location to drill a hole for the faucet on your sink.
Installation of hot and cold water supply line valves Cold Configuration for 1/2” Configuration for 3/8” Supply Supply compression fittings compression fittings Hand tighten brass adapters then apply 1/4 turn with a wrench. RO Tubes will be connected on page 7 Step 6 Turn off the hot and cold water supply to the faucet by turning the angle stop valves off.
Mounting the RO module Step 10 Determine the best location for the RO Module to be mounted and allow for future system maintenance. Use a Phillips screwdriver and secure the screws 5 3/4” apart and 16” from the bottom of the cabinet. Note: There will be (2) Blue, (1) Green and (1) Black tubes coming from the module.
Blue Tube Connection (From The RO Module To TANK) Position tank in desired location. Stand it upright or lay it on Step 17 its side (using the black plastic stand). Measure the blue tube (marked “TANK”) from the RO module to the tank and cut it to length leaving a straight, square edge.
√ Stage 1 - Sediment Filter (part #: 104017) √ Stage 2 - Carbon Block Filter (part #: 101009-White End Caps) Note: The filter wrench pictured (Part # 164003) may be purchased from Watts Premier to aid with twisting off filter housings but is not required. Step 1 Close the ball valve on the RO storage tank and open the RO Faucet.
TDS reduction falls below 75%. A water sample may be sent to Watts Premier for a free diagnosis of your membrane performance. To send a water sample, use two (2) clean containers and fill ½ cup of tap water in one container and ½...
Check Air Pressure in the Tank Check air pressure only when tank is empty of water! Important: Check air pressure in the storage tank when you notice a decrease in available water from the RO system. Air can be added with a bicycle pump using the schrader valve that is located on the lower side of the tank behind a blue plastic cap.
Adjust Faucet If the faucet has developed a drip it can be corrected by following the steps outlined below. Step 1 Remove faucet Spout first. Position both thumbs on the back edge of the lever and push forward. Step 2 Lever will slide forward and completely off of the faucet base.
PerformanceData Sheet ZRO-4 Zero Waste RO Watts Premier Inc. 1725 W. Williams Drive C-20 Phoenix, AZ 85027 USA (623) 931-1977 wpmail@wattsind.com GENERAL USE CONDITIONS: 1. System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe quality. Do not use with water that is microbiologically unsafe or unknown quality without adequate disinfection before and after the system.
This Watts Premier reverse osmosis system is designed to remove pentavalent arsenic. It will not convert trivalent arsenic to pentavalent arsenic. Under laboratory standard testing conditions, this system reduced 0.30 mg/L (ppm) pentavalent arsenic to under 0.010...
Item # Part # Description Item # Part # Description 137013 BRACKET-4SV-STEEL WHITE 116023 FAUCET-AG-CHROME 146001 SCREW- #10-3/4” PHIL PAN HEAD 134018 VALVE-BALL-PLAS-ELB 146004 SCREW- #10-1” PHIL PAN HEAD 119007 TANK PRESS 3 GAL WHITE 164006 CLIP-MTG-MEM-VESSEL 119028 TANK STAND 337002 BRACKET 16 GAUGE CRS 125017 CON-PL-1/4C X 1/4M 113007 LID-WHITE 1/4”...
Other Products from Watts Premier Watts Premier has other fine water filtration products and accessories to enhance your water and to compliment your existing RO System. Listed on the next several pages are only a few of the items we offer.
Page 19
Replacement Filter Kit Compatible with Watts Premier Zero Waste Reverse Osmosis system. These filters provide an extra level of filtration by allowing for more contact between the carbon media and your water. Includes a 10” Final in-line Filter, Sediment Filter and a Carbon Block Filter.
Removing chlorine from your shower Special Chlorgon & KDF media – More effective then carbon medias with hot water applications in the removal of the following. √ Free Chlorine (CL-) √ Iron oxide (rust water) √ Combined Chlorine (Sodium Hypochlorite) √...
Watts Premier collects personal information when you register with Watts Premier. This information is stored in our data base and we do not rent, sell, or share personal information with other people or nonaffiliated companies.
Page 22
Iowa Department of Public Health - Sales in Iowa require this to be completed, signed and returned. These signatures will be retained on file for two years. Insert into envelope and return to Watts Premier Watts Premier 1725 W. Williams Dr. C-20...
SERVICE RECORD DATE OF PURCHASE DATE OF INSTALL INSTALLED BY SERIAL NO. NAME: Date of (6 mos.) (6 mos.) (1 yr.) (2-5 yrs.) OTHER Maintenance 1st stage 2nd stage Final Filter TFM Memb. Sediment Carbon Block Carbon NOTES:...
If any part of your WATTS PREMIER Zero Waste Reverse Osmosis System is defective in workmanship (excluding replaceable filters and membranes), return unit after obtaining a return authorization (see below), less tank, within 1 year of original retail purchase, WATTS PREMIER will repair or, at WATTS PREMIER’S option, replace the system at no charge.