Panel Mounting (Afl-10A-Cx/Afl-12B-Cx Only); Figure 3-19: Arm Mounting Retention Screw Holes (Afl-15A/17A/19A-Cx) - IEI Technology AFOLUX CX Series User Manual

Figure 3-19: Arm Mounting Retention Screw Holes (AFL-15A/17A/19A-CX)

Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel PC.
Step 0:

3.8.3 Panel Mounting (AFL-10A-CX/AFL-12B-CX Only)

To mount the AFL-10A-CX/AFL-12B-CX flat panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the panel to mount the flat panel PC.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions
of the flat panel PC. Take care that the panel section that is cut out is smaller
than the overall size of the metal frame that surrounds the flat panel PC but just
large enough for the rear panel of the flat panel PC to fit through (Figure 3-20
and Figure 3-21).
Page 46
AFOLUX CX Series Flat Panel PC