Arm Mounting; F Igure 3-17: Tighten The Panel Mounting Clamp Screws (Afl-10A/12A - IEI Technology AFL LX Series User Manual

Figure 3-17: Tighten the Panel Mounting Clamp Screws (AFL-10A/12A-LX)

3.8.3 Arm Mounting

The AFOLUX LX series is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 75mm or 100mm interface pad. To mount the AFOLUX
LX series on an arm, please follow the steps below.
The arm is a separately purchased item. Please correctly mount the arm onto
Step 1:
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFOLUX LX series flat panel
PC. The AFL-10A-LX and AFL-12A-LX also support VESA MIS-D 100.
Page 50
AFOLUX LX Series Flat Panel PC