Advantech MIC-3359 User Manual page 34

read/write. If your IDE hard drive supports block mode (most new drives do), select
Enabled for automatic detection of the optimal number of block read/writes per sector
the drive can support. The settings are: Enabled (Default), Disabled.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has no
floppy drive, select Disabled in this field. The settings are: Enabled (Default) and
Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial ports.
The Serial Port 1 settings are: 3F8/IRQ4 (Default), 2F8/IRQ3, 3E8/IRQ4, 2E8/ IRQ3,
Disabled, Auto. The Serial Port 2 settings are: 3F8/IRQ4, 2F8/IRQ3 (Default),
3E8/IRQ4, 2E8/ IRQ3, Disabled, Auto.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides
Standard, ECP, and EPP features. It has the following options: Disabled, 378/IRQ7
(Default), 278/IRQ5, 3BC/IRQ7 and Disabled.
Parallel Port Mode
Default Spp
EPP1.9+SPP
ECP
EPP Mode Select
Default is EPP 1.7.
Standard Parallel Port
Support both the SPP and EPP1.9 modes.
Extended Capability Port
MIC-3359 User Manual --- Page 26