Specifications - Advantech MIC-3359 User Manual

Mic-3000 series 6u compactpci intel desktop pentium 4 & mobile pentium 4-m processor board with vga on board
Table of Contents

Advertisement

1.2 Specifications

Standard SBC Functions
•CompactPCI Bus Interface
PICMG 2.0 Rev. 3.0 compatible, 5V signaling; 32 bit/33 MHz, REQ/GNT for 7 slots;
Operates in system slot as system master
®
®
®
®
• CPU: Intel
Pentium
4 / Intel
Celeron
, 478-pin package FC-PGA
Mobile Pentium 4 Processor-M from 1.2 GHz up to 2.2 GHz for low power
dissipation (higher frequencies on request), Desktop Pentium 4 from 2 GHz up to 2.8
GHz for high performance, 512 KB full speed L2 on-die cache, 400 MHz and 533 MHz
processor front-side bus, passive heat sink for the processor, at least 300 LFM forced
air cooling required in the chassis.
• BIOS: 4 Mb Firmware Hub (FWH) using Award BIOS
®
• Chipset: Intel
845GV/ICH4 Chipset
Host Interface Support for Intel processor in an mPGA478 package
Hyper-Threading Technology support
Support Hub Interface 1.5 (266 MB/s point-to-point Hub Interface to the ICH4)
Integrated Graphics, core frequency of 200 MHz, resolution up to 2048 x 1536 x 60Hz
x 8 bit, shared memory up to 64MB
®
®
• Front Side Bus: 400MHz/533 MHz (Intel
Pentium
4 processor-M Processor)
• Bus Interface: 32-bit/33 MHz, PICMG 2.16 compliant
• Memory: Double Data Rate (DDR) SDRAM Configuration
Up to 2.0 GB of 200 MHz or 266 MHz DDR SDRAM
Two DDR DIMMs, single-sided and/or double-sided, DDR 200/266 unregistered,
184-pin non-ECC DDR
• Ethernet: the MIC-3359 uses the Intel@82562ET LAN chip for 10/100 Mb Fast
Ethernet, with an option for the Intel® 82551ER 10/100 Mb for Fast Ethernet which is
pin-to-pin compatible with the Intel® 82540EM 10/100/1000 Mb for Giga Ethernet.
MIC-3359 supports one 10/100Mb LAN; MIC-3359-A supports two 10/100Mb LANs;
MIC-3359-B supports one 10/100Mb LAN, and one Gb LAN.
• Enhanced IDE interface: The IDE interface supports two channels. The master for
the primary channel is reserved for the Compact Flash. The secondary IDE channel
can be connected to a RIO module via the J3 connector. The interface supports PIO
mode 4 and ATA 33/66/100 mode.
MIC-3359 User Manual --- Page 4

Advertisement

Table of Contents
loading

Table of Contents