Condition 3
Area -a-
Replenish the oil level. It is sufficient for the oil
level to be anywhere within area -b-.
Area -b-
It is not necessary to replenish the oil.
Area -c-
The oil cannot be replenished
Note
With the oil level below the minimum marking (area -a-), you
♦
must replenish the oil until it reaches the (area -b-) according
to the oil specification.
With the oil level above area -c- there is the risk of damaging
♦
the catalytic converter.
During oil changes, you must add oil until the maximum mark‐
♦
ing.
4.20
Engine and components in engine com‐
partment (from above and below) -
make a visual inspection for leaks and
damage
The visual inspection must be carried out as follows:
– Check the engine and components in the engine compartment
for leaks and damage.
– Check the cables, hoses and connections of the following sys‐
tems for leaks, wearing, porosity and brittleness:
♦ fuel supply system.
♦ cooling and heating system.
♦ brake system.
Note
Make sure that all existing faults are properly eliminated during
♦
repair.
In case of movement of brake fluid not caused by pad wearing,
♦
you must determine and eliminate the cause (repair measure).
4.21
Poly-V belt - check the condition
Carry out work sequence as follows:
– Lift the vehicle.
⇒ page 58
FOX 2004 ➤
Maintenance - Edition 07.2010
4. Service descriptions
65