Vehicle Identification Data - Volkswagen FOX 2004 Service Manual

FOX 2004 ➤
Maintenance - Edition 07.2010
– The Diagnosis, Measurement and Information System sends
all known keywords in sequence.
If a command unit replies with its identification, the display informs
the number of faults or "No fault detected".
Any faults stored in a system will be listed. Then, the Diagnosis,
Measurement and Information System -VAS 5051A/52- sends
the next keyword.
The automatic verification process is completed when the follow‐
ing indication is displayed:
– On display, press the "Print" key -1- and, in the print menu,
press "Screen".
The Diagnosis, Measurement and Information System prints all
faults or "0 fault(s) detected". If there are faults stored in the sys‐
tem, repair measures are required. The fault protocol must be
sent together for repair.
– On the display press the "Skip" key -2-.
Indicated on display:
– On the display press the "End" key -arrow-.
– Press the "End" key on the conclusion menu.
– Switch the ignition off and disconnect the diagnosis connector.
3.5

Vehicle identification data

3.5.1 Vehicle identification number"VIN"- lo‐
cation
The vehicle identification number (chassis number) -arrow- is
marked on the floor plate below the back seat and close to the
fuel pump access cover.
3.5.2 VIS tag - location
Destructive label with partial chassis number (VIS).
26
3. General remarks