Volkswagen FOX 2004 Service Manual page 67

– Loosen the filter through the hex section -arrow- with a 36 mm
Wrench .
WARNING
♦ Follow the rules for disposal!
– Clean the engine sealing surface.
– Replace the sealing ring.
– Lightly lubricate the new filter rubber sealing. With this, the
filter is better seated and ideal sealing condition is achieved.
Tightening torque for the filter: 25 Nm.
Engine identification letters BMD
Carry out the following work sequence:
– Loosen the cover -5- with a Wrench -SW 36- and remove the
cover with the filter.
– Remove the filter -1-.
– Replace the cover sealing ring -4-.
– Replace the sealing rings -2- and -3-.
WARNING
♦ Follow the rules for disposal!
– Clean the engine sealing surface.
– Lightly lubricate the new filter rubber sealing. With this, the
filter is better seated and ideal sealing condition is achieved.
Tightening torque: 25 Nm.
4.19.2 Replenish the engine with oil
Based on the oil properties
approved engine oils:
4.19.3 Oil specification for engine identification
letters AQZ, BAH, BLH, BKR, BMD
– Vehicles with "service based on time and kilometers
traveled" (QG0): VW 502 00.
4.19.4 Oil specification for diesel engines with
identification letters ASY
– Vehicles with "service based on time and kilometers
traveled" (QG0): VW 505 00 or VW 505 01.
4.19.5 Oil specification for diesel engines with
identification letters BNM
– Vehicles with "service based on time and kilometers
traveled" (QG0): VW 505 01.
⇒ page 29 , use only the following
FOX 2004 ➤
Maintenance - Edition 07.2010
4. Service descriptions
63