Crestron DM-RMC-100-C Operations & Installation Manual page 17

Crestron DM-RMC-100-C
Operations & Installation Guide – DOC. 7000C
Connectors, Controls & Indicators
# CONNECTORS
CONTROLS &
INDICATORS
5 LAN
Pin 1
Amber Green
LED LED
6
4
DM IN
7
Pin 1
Amber
Green
LED
LED
8 RESET
SETUP
9
(Button and LED)
10 24 V
0.75A MAX
11 Power LED
1. Interface connectors for the COM and IR ports are provided with the unit.
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI signal. CBL-HD-DVI
interface cable sold separately.
3. Maximum string length for serial commands sent via the IR port should be no greater than
40 characters.
DigitalMedia 8G+ Receiver 100
1
, DESCRIPTION
(1) 8-pin RJ-45 female, shielded, with two
LED indicators;
10BASE-T/100BASE-TX Ethernet port;
Green LED indicates Ethernet link status;
Amber LED indicates Ethernet activity
PIN SIGNAL
1 TX +
2 TX -
3 RX +
4 N/C
(1) 6-32 screw, chassis ground lug
(1) 8-pin RJ-45 female, shielded, with two
LED indicators;
DM 8G+ input, HDBaseT compliant;
PoDM and PoH PD (Powered Device) port
Connects to the DM 8G+ output of a DM
switcher, transmitter, or other DM device, or
to an HDBaseT device via CAT5e or
Crestron DM-CBL-8G cable
Green LED indicates DM link status;
Solid amber LED indicates HDCP video;
Blinking amber LED indicates non-HDCP
video
(1) Miniature recessed push button for
hardware reset
(1) Miniature recessed push button for
Ethernet setup and (1) red LED
(1) 2.1 x 5.5 mm dc power connector;
24 volt dc power input;
Power pack included
(1) Green LED, indicates operating power
supplied from local power pack, PoDM, or
PoH
DigitalMedia 8G+ Receiver 100: DM-RMC-100-C  11
PIN SIGNAL
5 N/C
6 RX -
7 N/C
8 N/C
5
;
6
;