Crestron DMF-RMC-4K-SFP Do Manual

DO GUIDE
DMF-RMC-4K-SFP
DigitalMedia SFP+ 4K Fiber Receiver
™
DO

Install the Device

The Crestron DMF-RMC-4K-SFP can be mounted onto a flat surface or onto a rack rail.
®
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a flat surface such as a wall.
Mounting onto a Wall
Mounting onto a Rack Rail
Using two mounting screws (not included), mount the left or right mounting flange of the device
onto the front or rear rail of a rack.
Mounting onto a Rack Rail
DO

Check the Box

QTY PRODUCT
1 Cable, RJ-45 Male - DB9 Female, 6' (1.83 m)
1 Connector, 4-Pin
2 Connector, 5-Pin
1 Power Cord, 5' 10" (1.78 m)
1 Power Pack, 24 Vdc, 2.5 A, 100-240 Vac
DO

Connect the Device

Connect the device as required for the application.
Top View
To/from To/from
serial port USB port
on PC on PC
(cable included)
Bottom View
10BASE-T/ From DM OUT
100BASE-TX/ port of
1000BASE-T DigitalMedia™
Ethernet to SFP+
LAN or local transmitter
network device*
*To connect to the LAN, use either the LAN port of the DMF-RMC-4K-SFP or the LAN port of the DigitalMedia SFP+
transmitter (DMF-TX-4K-SFP or DMCF-TX-4K-SFP)—do not connect the receiver and transmitter LAN ports to the
LAN simultaneously.
† Use Crestron SFP+ transceiver modules only. Refer to the SFP-10G Series DO Guide (Doc. 7862) for
®
additional information.
PART NUM.
2043246
2003576
2003577
2042043
2045873
To IR
To/from Ground
controllable RS-232
devices
device
24 Vdc from
power pack
(included)
To From HDMI
Balanced/
HDMI audio/video
® unbalanced
display source
stereo line
level audio
† output