Configure the WET11 for EdgeTech wireless networking
Follow these steps to use the laptop's Web Browser (Internet Explorer) to configure
the Linksys WET11 Ethernet Bridge using a wired Ethernet connection.
Before proceeding to the actual setup, ping the WET11 from the laptop to test the
wired Ethernet connection. Run "ping 192.168.1.225 -t" from the Windows command
shell. If this ping fails then repeat the steps to "Prepare a replacement WET11 for
wired access configuration" and refer to "Troubleshooting wired LAN Ethernet
connection". If it still fails, contact Linksys for support ((http://www.linksys.com).
1.
Start a Web Browser, for example: Internet Explorer.
2.
In the Web Browser's Address field, type
3.
WET11 Logon page: leave the User name blank and type "admin" as Password
(all lower case), then click the "OK" button to log on.
A
A
P
P
E
N
P
P
E
N
http://192.168.1.225
A-9
A
–
W
S
A
–
W
S
D
I
X
I
R
E
L
E
S
S
E
D
I
X
I
R
E
L
E
S
S
E
and hit "Enter".
990-0000058-1000
Rev. B
T
U
P
T
U
P
Need help?
Do you have a question about the Model 3100P Sub-bottom Sonar System and is the answer not in the manual?