Connecting With Keyboard Wedge - Honeywell Xenon 1900 User Manual

3. If you are connecting a CCB01-010BT Base, make sure the cables are secured in the wireways in the bottom of the
cordless base and the base sits flat on a horizontal surface. If you are connecting a CCB02-100BT Base, see
a CCB02-100BT Base
4. The scanner beeps.
5. Verify the scanner or cordless base operation by scanning a bar code from the
manual.
The unit defaults to a USB PC Keyboard. Refer to
For additional USB programming and technical information, refer to "USB Application Note," available at
wellaidc.com.

Connecting with Keyboard Wedge

A scanner or cordless base can be connected between the keyboard and PC as a "keyboard wedge," where the scanner
provides data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the terminal/computer.
2. Connect the appropriate interface cable to the device and to the terminal/computer.
3. If you are connecting a Granit scanner, make sure the cable is pushed tightly into the scanner. Loosen the locking plate
and slide it over the base of the cable connector to lock the cable in place. Tighten the screw.
on page 1-8.
page 2-3
Corded Xenon Scanner
Keyboard Wedge
Connection:
Corded Granit Scanner
Keyboard Wedge
Connection:
Sample Symbols
for other USB terminal settings.
Mounting
in the back of this
www.honey-
1 - 3