2D Reread Delay; User-Specified Reread Delay - Honeywell Xenon 1900 User Manual

Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save. Default = 5,000 ms.
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a
4-7). Default = Medium.
Short (500 ms)
Long (1000 ms)

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the bar code below, then set the delay (from 0-30,000 millisec-
onds) by scanning digits from the inside back cover, then scanning Save.

2D Reread Delay

Sometimes 2D bar codes can take longer to read than other bar codes. If you wish to set a separate Reread Delay for 2D
bar codes, scan one of the programming codes that follows. 2D Reread Delay Off indicates that the time set for
Delay is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
* 2D Reread Delay Off
4 - 12
Hands Free Time-Out
User-Specified Reread Delay
Presentation Mode (see page
* Medium (750 ms)
Extra Long (2000 ms)
Reread