System Requirements - Proxim ORiNOCO AP-800 Hardware Installation Manual

2.1.1.3 Power Socket
This socket connects to the 5 VDC power adapter.
2.1.1.4 Reset
Reset button enables a user to powercycle the device.
2.1.1.5 Reload
Reload feature helps to restore the device to factory default configuration, when:
– The device cannot be accessed through web interface or command line interface.
– The device does not initialize.
– The password is lost.
For more details, see Recovery Procedures and Forced Reload procedures, detailed in the ORiNOCO® 802.11n Access Points -
Software Management Guide.
2.1.1.6 Ethernet Port
The Ethernet Port of the device allows the user to connect to the LAN by using CAT5e / CAT6 ethernet cable.
2.1.1.7 Serial Port
The device has RS-232 connector by using which serial communication can be established, for debugging and management.

2.1.2 System Requirements

Following are the minimum system requirements to use the device:
1. Any 802.11 compliant wireless adapter.
2. A computer that is connected to the same IP network as the AP and has one of the following installed:
— Web Browser
— Telnet
— RS-232 Serial Port
— MIB Browser
— Ethernet NIC Card
3. Ethernet switch, cross-over or straight Ethernet cable.
4. A 5V DC Power Adapter or a Power over Ethernet (PoE) Adapter
ORiNOCO® 802.11n Access Points - Hardware Installation Guide
Figure 2-2 Rear View of the Device
Hardware Overview and Installation
10