Engine Oil - E-TON Viper 150 Owner's Manual

To replace the filter, first turn the fuel cock to the
"OFF" position. Then carefully compress the wire
clamp rings until the clamp is free of the fuel line.
Slide each clamp away from the filter about 3/4".
Remove the filter from the fuel line by holding the
line and pulling the filter. Install the new filter by
inserting the filter into the fuel line and returning
the clamps to the original position.
Turn the fuel cock to the "ON" position and check
for leaks. Inspect the fuel lines for cuts, abrasions
and deterioration. Replace fuel lines as needed.
DO NOT operate or start the engine if the fuel
filter or lines are leaking. Leaking fuel can cause
a fire.
8
To change the inline fuel filter (for OTHER)
To replace the filter, carefully compress the wire
clamp rings until the clamp is free of the fuel line.
Slide each clamp away from the filter about
Remove the filter from the fuel line by holding the
line and pulling the filter. Install the new filter by
inserting the filter into the fuel line and returning
the clamps to the original position
Start the engine and check for leaks. Inspect the
fuel lines for cuts, abrasions and deterioration.
Replace fuel lines as needed.
DO NOT start or operate the engine if the fuel filter
or lines are leaking. Leaking fuel can cause a fire.
1. Inline fuel filter

Engine oil

The engine oil level should be checked before
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
3/4".
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.
8-11
1