CognitiveTPG A776 Programming Manual page 96

84 Chapter 5: Programming commands
Transmits the printer ID specified by n as follows:
n Printer ID Specification
1, 49 Printer model ID CognitiveTPG A776
2, 50 Type ID Installed options
3, 51 ROM version ID ROM version
4, 52 Logo definition Logo definition
n = 2 or 50: Type ID
Type ID (n = 2)
Bit Off/On Hex Decimal
0 Off 00 0
On 01 1
1 Off 00 0
On 02 2
2 - - -
3 Off 00 0
On 08 8
4 Off 00 0
5 Off 00 0
On 20 32
6 - - -
7 Off 00 0
n = 4 : Logo Definition
Bit Off/On Hex Decimal
0 Off 00 0
On 01 1
1 - - -
2 - - -
3 - - -
4 Off 00 0
5 - - -
6 - - -
7 Off 00 0
Transmits the printer ID specified by n. This command is a batch mode command; that is, the response is transmitted
after all prior data in the receive buffer has been processed. There may be a time lag between the printer receiving this
command and transmitting the response, depending on the receive buffer status.
A776 (B780) Programming Guide
ID (Hexadecimal)
0x2B (A776)
0x2A (A760)
0x28 (A758)
0x26 (A756)
0x2C (B780)
0x0A (A721)
Refer to the table below
0x00
Refer to table
next column
Function
No two-byte character
code installed.
Two-byte character
code installed.
No knife installed.
Knife installed.
Undefined.
No MICR installed.
MICR installed.
Not used. Fixed to Off.
No imager installed.
Imager installed.
Undefined
Not used. Fixed to Off.
Function
No logo definition loaded by application.
Logo loaded by application
Undefined
Undefined
Undefined
Not used, Fixed to Off.
Undefined
Undefined
Not used, Fixed to Off.
A776-PG00001 C 12/09