Convert 6-Dots/Mm Bitmap To 8-Dots/Mm Bitmap; Enable Constant Speed Logos - CognitiveTPG A776 Programming Manual

Related information
This command is utilized in the CognitiveTPG LogoEZ
a default colorization set-up without requiring any application changes. The default set-up was designed to provide a
general level of colorization features that would not affect the printer operation. You can expand beyond the default
features of the utility by modifying the application at the host. However, do not attempt to modify the settings within
the utility.
f = 1: s = 1H
a = 30H
f = 2: s = 32H
r = 19H
f = 3: s = 1H
r = 7H
t = 1H
f = 4: s = 30H
a = A0H

Convert 6-dots/mm bitmap to 8-dots/mm bitmap

ASCII
US EOT n
Hexadecimal
1F 04 n
Decimal 31 04 n
Value:
0 = Off
1 = On
(When 0 and 1 are the LSB)
Default:
0 (Off )
Selects or cancels 6-dot/mm to 8-dot/mm graphic emulation.
When the 6-dot/mm emulation is selected, logos and graphics are expanded horizontally and vertically during
download to emulate their size on a 6-dot/mm printer. The horizontal positioning commands also emulate positioning
on a 6-dot/mm printer.

Enable constant speed logos

ASCII US { n
Hexadecimal
1F 7B n
Decimal 31 123 n
Value: 0 = disabled
1 = enabled
This command allows the firmware to determine the optimal speed to print a logo. It is set prior to downloading the
logo and reset after the logo has been downloaded.
In general, the "Set max target speed (1D A0 nl nh)" is the preferred command.
A776-PG00001 C 12/09
Chapter 5: Programming commands
utility. The utility can be used to pre-configure new printers with
®
A776 (B780) Programming Guide
81