Select Print Mode; Select Or Cancel User-Defined Character Set - CognitiveTPG A776 Programming Manual

Select print mode

ASCII ESC ! n
Hexadecimal
1B 21 n
Decimal 27 33 n
Value of n:
Pitch selection (standard, compressed, double-high, or double-wide.)
Value of n
Bit Function
Bit 0 Pitch
(See chart below)
Bit 3 Emphasized mode Canceled
Bit 4 Double-high
Bit 5 Double-wide
Bit 7 Underlined mode
Bits 1, 2 and 6 are not used.
Standard and compressed pitch cannot be used together in the same line.
1
Slip Default is standard pitch on A776 and compressed pitch on B780.
Selects the print mode: standard, compressed, double-high, or double-wide.
Default: 00
Pitch Receipt Receipt
Station CPI
Standard 44 15.6
Compressed 56 20.3
Related information
Double-high can be enabled or disabled for the slip. Default is disabled for the slip on A776, and enabled on B780.
The bits in this command perform the same function as the stand-alone functions:
1B 16 n
1B 45 n
1B 47 n
12
13
1B 2D n

Select or cancel user-defined character set

ASCII ESC % n
Hexadecimal
1B 25 n
Decimal 27 37 n
Value of n:
0 = Code Page 437
1 = User Defined (RAM)
2 = Code Page 850
Range of n:
0–2
Default: 0 (Code Page 437)
Selects the character set. When an undefined RAM character is selected, the code page 437 character is used. Look in
Appendix B for the character sets.
Exception:
The character sets cannot be used together on the same line.
A776-PG00001 C 12/09
0 1
Standard Compressed
1
pitch pitch
Set
Canceled Set
Canceled Set
Canceled Set
Slip Slip
Station CPI
42 13.9
51 17.1
Select pitch
Emphasized
Double-strike
Double-wide
Single-wide
Underline
Chapter 5: Programming commands
A776 (B780) Programming Guide
55