Set Page Mode Margin Mechanical Adjustment; Select A776 Slip Eject Option; Select 45/60 Column Slip Option; Set Page Mode Option To Trim Full Dots - CognitiveTPG A776 Programming Manual

Set Page Mode Margin Mechanical Adjustment

Code (Hexadecimal)
1F 03 25 16 n
· This command applies to both the A776 and the B780, although it is primarily implemented for B780 printers
replacing existing A721 printers to match cashier check printing.
· Default is 0.
· Value is printed on the second diagnostic page.
· Ranges for margin configurations:
Margin Setting
"
.5
"
.3
"
.1
· Mechanical adjustment does not apply when page size is defined to be greater than the default of 200 full
dots wide.

Select A776 Slip Eject Option

Code (Hexadecimal)
1F 03 25 17 n
n
00
01
. When enabled, the A776 will eject slip and validation transactions out the top of the printer, like the B780. The
slip LED will blink to remove the form, also like the B780.
· Option can be disabled for applications that rely on the A760/A758/A756 slip eject out the bottom front
position.

Select 45/60 Column Slip Option

Code (Hexadecimal)
1F 03 25 18 n
n
00
01

Set Page Mode Option to Trim Full Dots

Code (Hexadecimal)
1F 03 2F n
n < 128 # of full dots trimmed from right side
n = 255 compress to fit in 3.024
. This command applies to both the A776 and the B780, although it is primarily implemented for applications
specifying a page size greater than 242 full dots wide.
· Default is no trim.
· Maximum width that can be compressed to fit in 3.024" is 270 full dots.
· Value is printed on second diagnostic page.
A776-PG00001 C 12/09
Maximum mechanical adjustment
30 half dots
56 half dots
84 half dots
Slip Eject
disabled
enabled (default)
45/60 Column Slip Option
disabled (default)
enabled
"
Chapter 3: Migrating to a new printer
A776 (B780) Programming Guide
13