Select Or Cancel Underline Mode; Copy Character Set From Rom To Ram - CognitiveTPG A776 Programming Manual

Each character is defined by 12 bytes (only bytes 2–11 are printed.)
Each byte is one column (full- or half-dot column.)
Overlapped dots are not printed.
The data must contain [(c2 - c1 + 1) x 12] bytes. (See illustration.)
Defines and enters downloaded characters into RAM or flash. The command may be used to overwrite single
characters. User-defined characters are available until power is turned off or the initialize printer command (1B 40) is
received.
Any invalid byte (s, c1, c2, n1) aborts the command.
User-defined character sets for both slip and receipt may be used at the same time.
s = 2 B780, slip only. Limited emulation of A721.
Related information
See 1D 22 n (select memory type where to save user-defined fonts.)

Select or cancel underline mode

ASCII ESC - n
Hexadecimal
1B 2D n
Decimal 27 45 n
Decimal Hex
Value of n: 0, 48 30 = Cancel underline mode
1, 49 31 = Select underline mode
2, 50 32 = Select double thickness
Default:
0 (Cancel underline mode)
Turns underline mode on or off. Underlines cannot be printed for spaces set by the horizontal tab, set absolute start
position, or set relative print position commands.
This command and the select print mode(s) command (1B 21) turn underline on and off in the same way.
Exceptions
This command is ignored if n is out of the specified range.

Copy character set from ROM to RAM

ASCII ESC : 0 0 0
Hexadecimal
1B 3A 30 30 30
Decimal 27 58 48 48 48
Default:
Code page 437
Copies characters in the active ROM set to RAM. Use this command to re-initialize the user-defined character set. Code
page 437 is copied by default at initialization. This command is ignored if current font is the user font.
Related information
To modify characters in one of the character set variations, such as rotated print, select one of the rotated print
commands, copy to RAM, then use the define user-defined character set command (1B 26).
A776-PG00001 C 12/09
underline mode
Chapter 5: Programming commands
A776 (B780) Programming Guide
57