Print Downloaded Bit Image; Convert 6-Dots/Mm Bitmap To 8-Dots/Mm Bitmap - CognitiveTPG A798 Programming Manual

64 Chapter 4: Programming Commands

Print downloaded bit image

ASCII
GS / m
Hexadecimal
1D 2F m
Decimal 29 47 m
Value and range of m:
This command is used to print a previously stored monochrome or color logo from printer memory on the receipt station.
The logo is identified as the one indicated by the most recent select current logo command or 0 if a select current logo
command has not yet been given. Parameter m is interpreted as follows:
Value of m Print mode Vertical DPI
0 Normal 203
1 Double wide 203
2 Double high 101
3 Quadruple 101
The indexed downloaded bit image from RAM or flash will be printed on the receipt station at a size specified by m. If
doubling or quadrupling exceeds the print paper width maximums (576 or 640 with 82.5mm paper) the left side of the
image is printed and the bits to the right of the maximum column are discarded. If the available width is greater than the
bit image, its printing will adhere to any currently set right, left, or center justification. This command is ignored if the
index refers to an undefined logo/ bit image.

Convert 6-dots/mm bitmap to 8-dots/mm bitmap

ASCII US EOT n
Hexadecimal
1F 04 n
Decimal
31 04 n
Value: 0 = Off
1 = On
(When 0 and 1 are the LSB)
Default:
0 (Off )
Selects or cancels 6-dot/mm emulation mode.
When the 6-dot/mm emulation is selected, logos and graphics are expanded horizontally and vertically during download
to emulate their size on a 6-dot/mm printer. The horizontal positioning commands also emulate positioning on a 6-dot/mm
printer.
Horizontal DPI
203
101
203
101
A798-PG00001D
Revision D 10/13