To Enter The Configuration Mode - CognitiveTPG A798 User Manual

20 Chapter 4: Using the Printer

To enter the configuration mode:

1 Turn power off to printer
2 Open connector cover (1).
3 Set DIP switch 1 to the ON position (down) (2). DIP
switch 2 should be in the OFF position (up).
4 Make sure receipt paper (3) is loaded in the printer
before proceeding. (See page 11.) Make sure cover is
closed.
5 Apply power to printer and immediately press and hold
the paper feed button until the configuration printout
begins.
• The printer beeps, then prints the diagnostics form
and the configuration main menu.
• The printer pauses and waits for a main menu
selection to be made (see sample printout on the
next page; short clicks are used, except when
answering "yes" or validating selection).
A798 Thermal Receipt Printer: User Guide
Set switch 1 to the
ON position (down)
Off
On
DIP Switches
Connector
Cover Open
Receipt
Cover
Receipt
Paper
Paper Feed
Button
6 To communicate with the printer, you will press the
paper feed button using either short or long clicks. Use
a long click for "yes" (more than one second) and a
short click for "no." Follow the printed instructions to
make selections.
7 Continue through your menu selections until you are
asked, "Save New Parameters?" Select "Yes."
a Return DIP Switch 1 to the OFF position (up).
b Reset the printer.
c Open the receipt cover.
Press and hold the paper feed button while closing
the receipt cover.
• The diagnostic printout verifies your new settings.
A798-UG00001 Rev. E1
1 2 1 2 1 2
10/2013