Bench Defaults - Keithley 2002 Getting Started Manual

Bench defaults

The Model 2002 can save one, v e, or ten user setups in non-volatile memory, depending on
the installed memory option. You can select one of the user setups as the power-on default, or
have the instrument power up to either of the two factory defaults (optimized for "BENCH" or
"GPIB" operation).
Since the basic measurement procedures in this manual assume the BENCH defaults, reset
the instrument from the SAVESETUP item of the MAIN MENU by performing the following
steps:
1.
2.
3.
4.
5.
Other BENCH default settings for DCV include:
•
•
•
•
Note: See MENUS in the MEASUREMENT OPTIONS section of this manual for details on
navigating the Main Menu.
Press the MENU key to display the main menu:
MAIN MENU
SAVESETUP GPIB CALIBRATION
TEST LIMITS STATUS-MSG GENERAL
If the SAVESETUP option is not blinking, press the
press ENTER to view the setup menu:
SETUP MENU
SAVE RESTORE POWERON RESET
Select the RESET option and press ENTER to view the reset menu:
RESET ORIGINAL DFLTS
BENCH GPIB
Select the BENCH option and press ENTER. The following message is displayed:
RESETTING INSTRUMENT
Enter to confirm; EXIT to abort
Press ENTER to con rm. The display will show DC voltage readings with auto-range
enabled.
Triggers — Continuous measurements.
Measurement speed (integration time) — Normal, 1 power line cycle.
Digital lter — Advanced, 10 readings, 1% noise tolerance, moving average, enabled.
Display resolution — 7.5 digits.
Front Panel Operation
key until it is blinking and then
1-9