Keithley 2002 Getting Started Manual page 67

:VOLTage:DC
:NPLC <n>
:AUTO <b>
:RANGe
[:UPPer] <n>
:AUTO <n>
:REFerence <n>
:STATe <b>
:ACQuire
:DIGits <n>
:AUTO <b>
:AVERage
[:STATe] <b>
:TCONtrol <name>
:COUNt <n>
:AUTO <b>
:VOLTage:AC
(DCV commands)
:COUPling <name>
:DETector
[:FUNCtion] <name>
:PWINdow <n>
:CURRent:DC
(DCV commands)
:METHod <name>
:CURRent:AC
(DCV commands)
:COUPling <name>
:DETector
[:FUNCtion] <name>
:RESistance
(DCV commands)
:OCOMpensated <b>
:FRESistance
(DCV commands)
:OCOMpensated <b>
IEEE-488 Bus Operation
Path to configure DCV:
Set speed: 0.01 to 10 PLC.
Enable or disable auto NPLC.
Path to configure measurement range:
Specify expected reading to select range.
Enable or disable auto range.
Specify reference (rel): -1100 to +1100.
Enable or disable reference (rel).
Use input signal as reference (rel).
Specify measurement resolution (see note 1).
Enable or disable auto resolution.
Path to control the filter (see note 2).
Enable or disable the filter.
Select filter type (
MOVing
Specify the filter count (1 to 100).
Enable or disable auto filter.
Path to configure ACV:
The commands listed to configure DCV apply.
Specify input coupling:
Path to select AC type:
Select AC type: ,
RMS
or .
NPEak PPEak
Specify window in seconds (0.1 to 9.9) for
or
PPEak
Path to configure DCI:
The commands listed to configure DCV apply.
Select measure technique:
Path to configure ACI:
The commands listed to configure DCV apply.
Specify input coupling:
Path to select AC type:
Select AC type:
RMS
Path to configure Ω2:
The commands listed to configure DCV apply.
Enable or disable offset compensation.
Path to configure Ω4:
The commands listed to configure DCV apply.
Enable or disable offset compensation.
3-13
or ).
REPeat
or .
AC DC
, , ,
AVERage PEAK LFRMs
NPEak
, .
NORMal ICIRcuit
or .
AC DC
or .
AVERage