Keithley 2002 Getting Started Manual page 68

3-14 IEEE-488 Bus Operation
:FREQuency
:TEMPerature
Notes:
1.
2.
:COUPling <name>
:REFerence <n>
:STATe <b>
:ACQuire
:DIGits <n>
:SOURce <name>
:THReshold
:CURRent
:RANGe <n>
:LEVel <n>
:VOLTage
:RANGe <n>
:LEVel <n>
:TTL
(DCV commands)
:TRANsducer <name>
:RTD
:TYPE <name>
:ALPHa <NRf>
:BETA <NRf>
:DELTa <NRf>
:RZERo <NRf>
Resolution ( ) parameters:
:DIGits
All functions except FREQ and TEMP — 3.5 to 8.5.
FREQ— 4 to 5.
TEMP — 4 to 7.
An advanced filter is available for DCV, ACV, DCI, ACI, Ω2, and Ω4. Refer to the User's
Manual to use the advanced filter.
Path to configure FREQ:
Specify input coupling:
Specify reference (rel): 0 to 15e6.
Enable or disable reference (rel).
Use input signal as reference (rel).
Specify measurement resolution: 4 or 5.
Select source:
CURRent
Path to configure threshold:
Path to set current threshold:
Specify range: 0 to 1.
Specify level: ±60% of max signal level.
Path to configure voltage threshold:
Specify range: 0 to 1000.
Specify level: ±60% of max signal level.
Set threshold to TTL level.
Path to configure TEMP (RTD):
DCV commands (except
Select transducer: ,
RTD
Path to configure RTD measurements:
Select parameters:
PT385
, or .
F100 USER
Specify alpha constant for USER: 0 to 0.01.
Specify beta constant for USER: 0 to 1.
Specify delta constant for USER: 0 to 5.
Specify rzero constant for USER: 0 to 1000.
or .
AC DC
or .
VOLTage
) apply.
:RANGe
or .
FRTD TCouple
, , ,
PT3916 PT100 D100