3-4
IEEE-488 Bus Operation
Primary address selection
The Model 2002 is shipped from the factory with a programmed primary address of 16. The
address is displayed on power-up. Programming examples in this manual assume a primary ad-
dress of 16.
Perform the following steps to check and/or change the primary address:
1.
2.
3.
4.
NOTE
5.
Press MENU to display the MAIN MENU.
Place the cursor on GPIB and press ENTER to display the GPIB/PRINT SETUP op-
tions.
Place the cursor on ADDRESSABLE and press ENTER to display the primary address.
To change the address, use the cursor keys and the range keys to display the desired ad-
dress and, press ENTER.
Each device on the bus must have a unique address. Typically, the computer uses ad-
dress 0 or 21.
Use the EXIT key to back out of the menu structure.