LifeSize Room 200 Installation Manual page 15

2. Insert the codec into its stand by aligning the pin holes at the base. Secure the codec in
the stand by tightening the bolt on the bottom of the codec stand. Optional: Insert the
rubber feet on the bottom of the codec stand. The codec is also designed to lay flat
should you choose not to install the stand.
Warning: Use only the stand and bolt included in the product box with the codec.
Using a stand and bolt from another LifeSize model can damage the codec.
Note: When using the stand, LifeSize recommends you route at least the thicker
cables (DVI and HDMI) through the plastic strain relief guide on the stand to enhance
the stability of the codec and prevent tipping. You can also remove the stand and lay the
codec flat to improve stability.
3. To connect a LifeSize Camera 200 to the codec, insert the HDMI cable into the HD port
on the rear side of the camera and plug the opposite end into the port marked with the
HD in 1 symbol
the power port on the rear side of the camera and plug the power adapter into a power
outlet.
Note: LifeSize Camera 200 is supported only when connected to HD in on the codec.
If you purchased a second LifeSize Camera 200 for use with LifeSize Room 200, insert
the HDMI cable for the second camera into the port on the rear side of the camera and
plug the opposite end into the port marked with the HD in 2 symbol
of the codec. Insert the power adapter cable into the power port on the rear side of the
camera and plug the power adapter into a power outlet. For more information about
using two cameras with your LifeSize Room 200 system, refer to your LifeSize Video
Communications Systems User Guide.
4. Insert the HDMI display cable into the port on the rear of your display and the opposite
end into the port marked with the display 1 symbol
you are using the codec in the upright position with the stand, LifeSize recommends you
route this cable through the strain relief guide on the stand.) Insert the display power
cord into a power outlet.
To connect a second display, insert the video display cable into the port on the rear of
your display and the opposite end into the port marked with the display 2 symbol
on the back of the codec. (If you are using the codec in the upright position with the
stand, LifeSize recommends you route this cable through the strain relief guide on the
stand.) Attach the display power cord to a power outlet. By default, the second display is
blank and displays a message directing you to configure preferences for the display.
After you complete the initial configuration, refer to "Configuring a Second Display" on
page 19 to complete this process.
LifeSize Room 200 Installation Guide
on the back of the codec. Insert the power adapter cable into
HD HD on the back of the codec. (If
on the back
HD HD
2
15