LifeSize Room 200 Installation Manual page 14

Installing a LifeSize Room 200 System
Before you install a LifeSize video communications system, read the document LifeSize
Safety and Regulatory Notices for important safety information. The document is available
on the documentation CD-ROM and from the Support page of www.lifesize.com.
Warning: Exercise care when connecting cables to the codec to avoid damaging
cables or the connectors on the codec. Face the back of the codec or ensure that all
connectors are visible when connecting a cable to the codec.
To install the components of your LifeSize system, remove all components from the product
packaging, including cables, and place them in the desired positions in your conference
room.
Warning: Do not place anything on top of or adjacent to the codec that can obstruct
air flow around the unit or generate heat. Doing so can cause the system to overheat
and reboot. Prolonged overheating can result in damage to the codec. Ensure the room
that houses the codec is properly ventilated and temperature controlled.
Refer to the quick reference card included with your system for a visual depiction of the
proper setup. The numbers that appear on the quick reference card correspond to the
following steps:
1. Open the battery compartment on the back side of the remote control.
a. Before inserting the batteries, stretch each of the two straps across the outer battery
slot closest to it.
b. Insert the two outer batteries, negative end (-) first against the spring, then press the
positive (+) end into place, trapping the cloth straps beneath the batteries.
c. Lay the longer cloth strap over both batteries and insert the center battery's negative
end against the spring first to trap the longer cloth strap beneath it. Then press the
positive end of the battery into place.
d. Lay the ends of the cloth straps over the center battery and install the cover.
14 LifeSize Room 200 Installation Guide