Figure 19: Attaching The Equipment Rack Brackets (Continued); Figure 20: Mounting The Switch In An Equipment Rack - Allied Telesis AT-x510-28GTX Installation Manual

Figure 19. Attaching the Equipment Rack Brackets (Continued)
5. While another person holds the switch in the equipment rack, secure it
using standard equipment rack screws (not provided), as shown in
Figure 20.
Figure 20. Mounting the Switch in an Equipment Rack
6. Repeat this procedure to install the remaining switches in the stack.
7. After installing the switches, go to Chapter 5, "Verifying the Status of
VCStack" on page 63 to verify that VCStack is enabled on the units.
x510 Series Installation Guide for Virtual Chassis Stacking
61