Installing And Replacing Infrared Burners - Cal Flame BBQ08873P Owner's Manual

Installing and Replacing Infrared Burners

1. Disconnect or shut off the liquid propane or
natural gas line connect to the grill. Wait until
the burners cool down.
2. Open the hood and remove the grate and flame
tamer on top of the burner you want to replace.
3. Through the access door underneath the grill,
find the round stud and locking pin that locks the
burner you want to replace.
4. Carefully remove the locking pin with your
fingers.
BTU Ratings
2010 Barbecue Grills
LTR20101038, Rev. A
5.
6.
7.
8.
9.
10.
11.
If you want to change back to regular burners, just
follow the procedure above in reverse order.
Main burners
Infrared burner CF 3 – 5
Infrared burner CF 4
Side burner
Raise the stud from the locking hole and move
the burner forward carefully to release it from
the ignition and gas supply valve.
Take the burner out of the grill and store it in a
safe and dry place.
Install the burner. Align the gas inlet on the
burner with the gas supply valve on the grill and
torch tube with ignition. Make sure they align
perfectly. Slide the stud at the other end into the
locking hole.
Adjust the infrared burner. Make sure the burner
is aligned and in position.
Repeat steps 2 through 9 if you want to replace
other burners.
Put back the grate you just removed. (You don't
need the flame tamer for infrared burners.)
Reconnect or turn on the gas line.
15,000 BTU
9,000 BTU
12,000 BTU
13,000 BTU
1.9mm
#54 DMS
#52 DMS
#50 DMS
www.calflamebbq.com
27