Replacement Cover; Installing And Replacing Infrared Burners - Cal Flame BBQ08873P Owner's Manual

28

Installing and Replacing Infrared Burners

1. Disconnect or shut off the liquid propane or natu-
ral gas line connect to the grill. Wait until the
burners cool down.
2. Open the hood and remove the grate and flame
tamer on top of the burner you want to replace.
3. Through the access door underneath the grill,
find the round stud and locking pin that locks the
burner you want to replace.
4. Carefully remove the locking pin with your fin-
gers.

Replacement Cover

One cover is used for all grill models and sizes. It can be ordered directly from Cal Flame customer service
or through your dealer. Use part number BBQC2345GB to order this item.
BTU Ratings
www.calflamebbq.com
5.
6.
7.
8.
9.
10.
11.
If you want to change back to regular burners, just
follow the procedure above in reverse order.
Main burners
Infrared burner CF 3 – 5
Infrared burner CF 4
Side burner
Raise the stud from the locking hole and move
the burner forward carefully to release it from
the ignition and gas supply valve.
Take the burner out of the grill and store it in a
safe and dry place.
Install the burner. Align the gas inlet on the burn-
er with the gas supply valve on the grill and torch
tube with ignition. Make sure they align perfectly.
Slide the stud at the other end into the locking
hole.
Adjust the infrared burner. Make sure the burner
is aligned and in position.
Repeat steps 2 through 9 if you want to replace
other burners.
Put back the grate you just removed. (You don't
need the flame tamer for infrared burners.)
Reconnect or turn on the gas line.
15,000 BTU
9,000 BTU
12,000 BTU
13,000 BTU
1.9mm
#54 DMS
#52 DMS
#50 DMS
Barbecue Grills
LTR50001038, Rev. B