Table of Contents
Advertisement
Removing and Replacing Infrared Burners
1.
Disconnect or shut off the gas line connect to the
grill. Wait until the burners cool down.
2.
Open the hood and remove the grate and flame
tamer on top of the burner you want to replace.
3.
Through the access door underneath the grill, find
the round stud and locking pin that locks the burner
you want to replace.
Replacement Covers
2 burner / 3 burner grill
4 burner grill
5 burner grill
2 burner / 3 burner cart
4 burner cart
Cal Flame 2008 Owner's Manual
LTR20081044, Rev. A
CVRBLT001
CVRBLT003
CVRBLT007
CVRCRT030
CVRCRT032
4.
Carefully remove the locking pin with your fingers.
5.
Raise the stud from the locking hole and move the
burner forward carefully to release it from the igni-
tion and gas supply valve.
6.
Take the burner out of the grill and store it in a safe
and dry place.
7.
Install the infrared burner. Align the gas inlet on the
burner with the gas supply valve on the grill and
torch tube with ignition. Make sure they align per-
fectly. Slide the stud at the other end into the locking
hole.
8.
Adjust the infrared burner. Make sure the burner is
aligned and in position.
9.
Install the locking pin. Through the access door un-
derneath the grill, find the stud to lock the burner in
place. Install the locking pin. Make sure the locking
pin is secured correctly.
10.
Repeat steps 2 through 9 if you want to replace oth-
er burners.
11.
Put back the grate you just removed. (You don't
need the flame tamer for infrared burners.)
12.
Reconnect or turn on the gas line.
If you want to change back to regular burners, just follow
the procedure above in reverse order.
5 burner with deluxe 2 side burner
Standard single flat side burner
Standard side by side flat burner
Deluxe double side burner
Deluxe double side by side burner
Appendix
CVRCRT036
CVRSBR050
CVRSBR052
CVRSBR054
CVRSBR056
Page 17
Advertisement
Table of Contents
