Converting From Lp To Ng - Cal Flame BBQ08873P Owner's Manual

Barbecue grills
Hide thumbs Also See for BBQ08873P:
Table of Contents

Advertisement

Converting from LP to NG

WARNING! You must have an authorized service technician perform this
procedure. If these instructions are not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life . Lloyd's Material
Supply (L .M .S .) will not be held responsible for an improperly converted gas grill .
All Cal Flame grills are manufactured as standard
liquid propane (LP) grills and can be converted to
burn natural gas (NG). There are two steps required
to convert a grill from LP to NG.
You must perform both steps.
Step 1: Switching the regulator behind the
grill
Step 2: Changing the burner orifices
The conversion kit provided with your grill may
include some or all of the parts shown at right,
depending on the size and model of your grill.
The kit contains orifices to convert main burners,
rear infrared burners, and the large infrared burner.
Your kit will have only the parts you need to convert
your grill.
Before you begin, make certain the LP gas source
has been disconnected from the grill.
To gain access to the NG regulator, tilt the grill
forward.
Step 1: Switching the regulator
behind the grill
The regulator in the image below has been removed from a grill to illustrate
this procedure.
1.
Remove the LP gas line.
2.
Remove the cap fitting from the end of the NG gas regulator.
3.
Place the cap fitting over the LP gas inlet.
4.
Insert a male flared fitting (
2010 Barbecue Grills
LTR20101038, Rev. A
If you are attaching a flex hose to the regulator,
you will need a fitting. The fitting requires a male
flare on the input end with a 1/2" MPT on the
output end. The flared male input end needs to be
the size of your flex tubing. You can also connect
the regulator directly to your NG gas service, which
will not require a flared fitting.
not provided) in the NG gas regulator.
NOTE: A flared fitting is NOT included
with your grill .
You will need:
13mm open end wrench
Male flared fitting
(not provided)
Pipe compound suitable
for natural gas
25
www.calflamebbq.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents