Panasonic KX-TDE100 Network Manual page 88

4.4.1 Registering IP Telephones
Basic Setting programming through the KX-HGT100
Follow the procedure below to programme the Basic Setting parameters through the KX-HGT100.
Note
•
Before programming these settings, it is recommended to set the IP address of the KX-HGT100. For
details about setting IP addresses, refer to "For KX-HGT100 SIP Telephones" in "4.2.1 Assigning the
IP Addressing Information".
•
It is necessary to turn off, then turn on the power of the KX-HGT100 after programming settings for
changes to take effect.
To start programming
Press PROGRAM.
To configure the Telephone Number/SIP ID
Select desired parameter.
To configure the SIP Password
Select "SIP Password".
To configure the Proxy Address/Registrar Address/SIP Domain
Select desired parameter.
To configure the Proxy Port/Registrar Port
Select desired parameter.
To end programming
Press PROGRAM.
88 IP Networking Guide
Hold INFORMATION for 3 seconds
while "Save speed dial?" is displayed.
Press OK.
Press OK.
Press OK.
Press OK.
Extension No.
Max. 32 digits
SIP Password
Max. 32 digits
IP Address
Enter the IP address of
the IPCMPR card.
Port No.
1–65535
Press OK.
Press OK.
Press OK.
Press OK.