Panasonic KX-TDE100 Network Manual page 57

2.
Not using a DHCP server when assigning IP addressing information
All the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.3.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)/KX-NT136
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
Select "Network".
IP Address*
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address (if required)
Select "Default Gateway".
To enter the IP address of the IP-EXT16 card (PBX IP Address)
Return to the
Menu screen.
ENTER
Continued on next page
Press "SETUP" when it is displayed.
ENTER
Select "Disable"
for DHCP setting.
1
ENTER
Subnet Mask Address*
ENTER
Default Gateway Address*
ENTER
KX-NT300 with software version 2.00 or later only
Select "PBX". ENTER
PBX IP Address
4.3.1 Assigning the IP Addressing Information
SETUP
Select "IP Address".
2
Select "PBX IP ENTER
Address".
ENTER
ENTER
ENTER
3
ENTER
Select "Primary
PBX".
IP Networking Guide 57