Program Upload/Download; Program Download (Sp5-827) - Ricoh B039 Service Manual

5.1.9 PROGRAM UPLOAD/DOWNLOAD

The BiCU software for this machine is upgraded using a flash memory card.
There are two program download procedures.
• SP5-826: Upload from the BiCU to a flash memory card.
• SP5-827: Download from a flash memory card to the BiCU.

Program Download (SP5-827)

[A]
NOTE: Be sure to turn off the main switch before inserting or removing the flash
memory. Installing or removing flash memory while the switch is still on
may result in damage to the BiCU or to the memory.
1. Turn off the main switch.
2. Remove the rear middle cover [A] (2 rivets).
3. Insert the flash memory card [B] into the card slot.
NOTE: Make sure that the printed "A" on the card is facing the outside of the
machine.
4. Hold down the Operation Switch and turn on the main switch.
5. To start the download, press the "1" key and then press OK.
6. The machine erases the current software, then writes the new software to the
BiCU. This takes about 60 seconds. If downloading fails, an error message
appears, as indicated below. If this occurs, repeat the download procedure.
7. After finishing the software download, turn off the main switch and remove the
memory card.
SM
USING SERVICE PROGRAM MODES
[B]
B039M934.WMF
5-41 B039/B040/B043