STAMP
2.4 STAMP
[C]
[A]
[B]
B379D507.WMF
This function is only for fax mode.
There is a stamp [A] between the 2nd transport roller [B] and the exit roller [C], and
its solenoid is controlled by the copier directly.
When the original reaches the stamp position, the DF feed motor stops. At 300
milliseconds after stopping the DF feed motor, the stamp solenoid turns on if the
page was sent successfully (immediate transmission) or stored successfully
(memory transmission). After stamping, the DF feed motor starts again to feed out
the document, and its speed is about 1.3 times the normal speed.
The stamping position on the original can be changed by adjusting SP6-010.
B379
7-10
SM