Sp Mode Tables; Sp1-Xxx (Feed) - Ricoh B039 Service Manual

5.1.1 SP MODE TABLES

NOTE: In the Function/[Setting] column:
• The related pop-up screen name and function name (if any) appear in
parenthesis following the function description.
• Comments are in italics.
• The setting range is enclosed in brackets, with the default setting written
in bold.
• An asterisk (*) after the mode number means that this mode's value is
stored in the NVRAM. If you do a RAM reset, all these SP modes will be
returned to their factory settings.
• DFU stands for Design/Factory Use only. Values marked DFU should
not be changed.
• IAJ means that you should refer to "Replacement and Adjustment –
Copy Image Adjustments" for more information.

SP1-XXX (Feed)

1
Mode Number/Name
001* Leading Edge Registration
1 Paper tray
2 By-pass
3 Duplex
002* Side-to-Side Registration
1 1st tray
2 2nd tray
3 3rd tray
4 4th tray
5 By-pass feed
6 Duplex
003* Paper Feed Timing
1 1st tray
2 2nd, 3rd, 4th trays
3 By-pass feed
4 Duplex
SM
USING SERVICE PROGRAM MODES
Function/[Setting]
Adjusts the printing leading-edge registration from each
paper feed station, using the Trimming Area Pattern (SP5-
902, No.10).
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 2 ± 1.5 mm
• Use the ! key to select "+" or "–" before entering the
value.
Adjusts the printing side-to-side registration from each
paper feed station, using the Trimming Area Pattern (SP5-
902, No.10). Adjustments are supported for all 4 possible
feed trays (including optional trays).
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 2 ± 1.5 mm
• The SP1-002-1 setting is applied to all trays, not just the
1st Tray. Settings for trays 2 to 4 are offsets relative to
the SP1-002-1 setting.
• For duplex copies, the value for the front side is
determined by SP1-002-1 to -4, and the value for the
rear side is determined by SP1-002-6.
• Use the ! key to select "+" or "–" before entering the
value.
Adjusts the amount of buckle the paper feed clutch
applies to the paper after the registration sensor is
activated. A higher setting applies greater buckling.
[0 ~ 10 / 5 / 1 mm/step]
[0 ~ 20 / 6 / 1 mm/step]
5-3 B039/B040/B043