Cautions - ScoutGuard SG-660 User Manual

3. Cautions

Be sure the camera's power is switched off before inserting or removing SD card
or batteries.
It is recommended to use new high-performance alkaline AA batteries or
rechargeable batteries, for prevent the liquid rot the battery depot.
Please make sure that the battery polarity matches that on the battery cover. Make
sure the polarities are correct.
In the test mode, the camera will shut down automatically after one minute if no
key is pressed, please turn on the power again if you want to continue.
Please be sure that no power interrupt occurs during firmware upgrade, otherwise
the upgrade process could be interrupted incorrectly. If any fault occurs after
improper upgrading process and the camera stops function properly, please return
the device to the seller for repair.
When the power switch is ON, please don't take out the SD card, battery and
remove the external DC power frequently.
When mount the product. In 3 meter region, avoiding temperature and motion
disturbances in front of device such as big leaf, strap and another heat sources to
prevent false triggering.
Avoiding temperature and motion disturbances in front of the device such as a
air-conditioner, air outlet of the chimney and other heat sources and spotlight to
prevent from false triggering and device's life)
Battery life will vary with operating temperature and the number of images taken
over time, typically, the trail camera will be able to capture several thousand
images before the batteries die.
Indoor, if you want to get more high quality audio recording, it is recommended
to open the bottom of the Mic rubber cover. Outdoor, if have raining or wet
weather, please don't the rubber cover. Avoid damage inside of the camera (PCB).
- 4 -