ScoutGuard SG-660 User Manual page 17

d) Press Menu return toTest mode
⑽ Time stamp : ON/OFF
This parameter defines whether the time should be stamped in the pictures and videos clips or
not.
Default setting: "ON"
In Time Stamp mode:
a) Press Up or Down to select ON/OFF
b) Press OK to save the current setting
c) Press Left for cancel setting operation without any saving and return to last step.
d) Press Menu return toTest mode
⑾ Set Clock : (month/date/year) the valid year from 2010-2030, time: hour/minute)
Default setting: as "01:01:2011 12:01"
In Set Clock mode:
a) Press Left or Right to select month/date/year—hour: mins
b) press Up or Down to change the value.
c) Press OK to save all current setting
d) Press Menu return to Test mode
⑿ Sensor Level : High/Normal/Low
This parameter defines the sensitivity of the PIR, the higher degree indicates that the camera
is more easily to be triggered by motion, taking more pictures or recording more videos, it is
recommended to use high sensitivity degree in room or environment with little interference, and to
use lower sensitivity for outdoor or environment with lots of interference like hot wind, smoke,
near window etc. Furthermore, the sensitivity of the PIR is strongly related to the temperature.
Higher temperature leads t lower sensitivity. Therefore it is suggested to set a higher sensitivity for
high temperature environment.
Default setting: Normal
In Sensor Level mode:
a) Press Up or Down to select High/Normal/Low
b) Press OK to save the current setting
c) Press Left for cancel setting operation without any saving and return to last step.
d) Press Menu return to Test mode
⒀ IR LED : ON/OFF
"ON" means IR LED is enable, the camera will work with IR LED when the light is not enough,
for capture the high quality picture; off means IR LED is disable, no working in the night time.
- 16 -