Removing The Processor And Heat Sink - NEC POWERMATE 2000 Service And Reference Manual

Removing the Processor and Heat Sink

A – Lock Lever (under heat sink)
B – Socket Tab (1 of 2)
C – Heat Sink
6. Remove the processor as follows.
!
Pull out on the processor socket lock lever just enough to release the
lever from the socket, then pivot the lever up to release the processor.
!
Carefully lift up on the processor and remove it from the socket. Store
the processor in a static free bag.
7. Install a replacement processor as follows.
!
Align the white triangle on the corner of the processor with the
corresponding white triangle on the socket.
!
Carefully align the processor pins with the socket pin holes and set the
processor into the socket.

If aligned correctly and the pins aren't bent, the processor seats in
the socket without forcing.

If the processor does not seat, check the processor alignment and
check for bent pins.
!
Pivot the lock lever down and press it in towards the socket until it locks
in place.
D – CPU Fan Screws (2)
E – CPU Fan
F – Retention Clip
Disassembly and Reassembly 3-19