Installing Bootmagic In A System With Windows Nt; Configuring Bootmagic - NEC POWERMATE 2000 Service And Reference Manual

See the documentation in the Userinfo folder for information about using
PartitionMagic, BootMagic™, and the recovery diskette program. Reading the
Userinfo files requires Adobe
on the NEC Application and Driver CD.
Note
the Windows NT operating system, see the next section,

"Installing BootMagic in a System with Windows NT."

Installing BootMagic in a System with Windows NT
BootMagic™ is a utility included in the PowerQuest PartitionMagic™ software.
See the previous section, "Installing PartitionMagic," for general installation
information.
If you have a Windows NT operating system, use the information in the
following section to correctly configure BootMagic.
If you already installed BootMagic and the configuration resulted in an error
message, see "Correcting the BootMagic Configuration."

Configuring BootMagic

If you have a system with the Windows NT operating system, use the following
procedure to correctly configure BootMagic.
1. Follow the instructions in the PartitionMagic Userinfo folder to install
BootMagic. When the "BootMagic Configuration" box appears at the end of
the installation, continue to the next step.
2. Configure BootMagic.
!
If you want to use BootMagic:
Click the
during the next bootup sequence and lets you select Windows NT as the
operating system.
!
If you do not want to use BootMagic:
Do not select the
does not appear at bootup.
3. Select
configuration process. Either choice, to enable BootMagic or to not enable
BootMagic, requires the SAVE/EXIT selection.
®
Acrobat
: If you are installing BootMagic in a system with
ENABLE BOOTMAGIC
ENABLE BOOTMAGIC
SAVE/EXIT in the BootMagic Configuration box to complete the
®
Reader. Adobe Acrobat Reader comes
button. The BootMagic menu appears
button. The BootMagic menu
PM 2000 Series Release Notes A-5