So-Dimm Upgrade Sockets; Supported So-Dimms; Sample So-Dimm Upgrade Paths - NEC POWERMATE 2000 Service And Reference Manual

SO-DIMM Upgrade Sockets

The system board has two 168-pin, gold-plated SO-DIMM sockets. (See the
figure "System Board Internal Connector, Socket, and Jumper
Locations - Side 1" for socket locations.) The sockets support up to 256 MB of
high-speed SDRAM memory. The sockets support SO-DIMM modules in
64-MB and 128-MB unbuffered non-ECC memory configurations.
The SO-DIMM modules
!
can be installed in one or two sockets
!
size can vary between sockets
!
speed must match the processor bus speed (100 MHz)
!
can be single- and double-sided.
See the following tables for supported SO-DIMMs and for sample SO-DIMM
upgrade paths. To determine the memory needed for a memory upgrade, see the
paragraph following the tables. To remove or install a SO-DIMM, see Section 3,
"Disassembly and Reassembly."
SO-DIMM Size
64 MB
128 MB
Total System
Memory
64 MB
128 MB
128 MB
192 MB
256 MB
If you do not know how much memory is installed in the system, check the
amount as follows.
1. On the Windows 98, Windows 2000, or Windows NT 4.0 desktop, point to
My Computer

Supported SO-DIMMs

Non-ECC Configuration
8 Mbit x 64
16 Mbit x 64

Sample SO-DIMM Upgrade Paths

SO-DIMM 0
64 MB
64 MB
128 MB
128 MB
128 MB
and click the right mouse button.
SO-DIMM 1
--
64 MB
--
64 MB
128 MB
System Board 4-7