NEC POWERMATE 2000 Service And Reference Manual page 41

Menu Item
Parallel Port
Mode
Base I/O
Address
Interrupt
Floppy Disk Controller
Base I/O
Address
Large Disk Access Mode
Local Bus IDE Adapter
QuickBoot Mode
Sound
DMI Event Logging
Event Log Capacity
Event Log Validity
View DMI Event Log
Clear All DMI Event
Logs
2-14 System Configuration
Advanced Menu
Settings (default is bold)
Disabled, Enabled, Auto
Setting at Enabled allows the user to configure the port.
Setting at Auto enables the BIOS or operating system to
configure the port.
Output Only, Bi-directional, EPP, ECP
Selects parallel port mode.
378, 278, 3BC
Selects the base I/O address for the LPT port.
IRQ5, IRQ7
Selects the IRQ for the LPT port.
Disabled, Enabled, Auto
Setting at Enabled allows the user to configure the controller.
Setting at Auto enables the BIOS or operating system to
configure the controller.
Primary, Secondary
Sets the base I/O address for the controller.
Other, DOS
Select DOS if using DOS operating system.
Select Other if using another operating system such as UNIX
or Novell NetWare.
Disabled, Primary, Secondary, Both
Enables the integrated local bus IDE adapter.
Disabled, Enabled
When Enabled, the BIOS does not test system memory above
1 MB or wait for ready signals, allowing a quick boot.
Enabled, Disabled
Select Disabled to turn off onboard sound.
Press Enter to access the following submenus.
Status only.
Status only.
Status only, press Enter to view.
No, Yes
Selecting No prevents clearing out the DIMM event logs.