Chevrolet Captiva C140 Manual page 61

RE REAR F RE RE RE AR F AR F AR FOG L AR F OG L OG LA A A A A MP INDIC OG L OG L MP INDICA A A A A T T T T T OR MP INDIC MP INDIC MP INDIC OR OR OR OR
Illuminates when the rear fog lamps are on.
See "REAR FOG LAMP" in the index.
DRIVER' ' ' ' ' S S DRIVER DRIVER DRIVER DRIVER S S S S S SAFET S S AFET AFET AFET AFETY BEL Y BEL Y BEL Y BELT REMINDER Y BEL T REMINDER T REMINDER T REMINDER T REMINDER
Driver's safety belt warning lamp comes on
for about a few seconds when the ignition
switch is turned ON, and then goes out. This
means that the system performs self-
checking. After the engine is started, unless
the driver's safety belt is securely fastened,
the lamp will flash for about 90 seconds and
then illuminate until the driver's safety belt
is fastened.
After that, if the vehicle speed goes over about
22km/h, the lamp will flash again along with
the warning chime for about 90 seconds and
then illuminate until the driver's safety belt
is fastened.
INSTRUMENTS AND CONTROLS 2–15
NOTE NOTE NOTE NOTE NOTE
If you f If you fast If you f If you f If you f asten the driver ast ast ast en the driver en the driver en the driver en the driver' ' ' ' ' s saf s safet et et et ety belt s saf s saf s saf y belt y belt y belt y belt
when the warming lamp comes on or when the warming lamp comes on or when the warming lamp comes on or when the warming lamp comes on or when the warming lamp comes on or
flashes after the system performs flashes after the system performs flashes after the system performs flashes after the system performs flashes after the system performs
selfchecking, the safety belt warning selfchecking, the safety belt warning
selfchecking, the safety belt warning selfchecking, the safety belt warning selfchecking, the safety belt warning
lamp will g lamp will g lamp will go out immediat lamp will g lamp will g o out immediat o out immediat o out immediat o out immediately ely. . . . . ely ely ely
If you want to stop the warning chime instead
of fastening the safety belt, do the followings:
When the ignition is ON, insert the latch plate
into safety belt buckle and then extract it. This
opeartion should be performed two times
within 10 seconds.
The warning chime will be able to sound again
a few minutes after the ignition is OFF.