Table of Contents
Advertisement
5–10 EMERGENCIES
10. Inflate the tyre to the recommended
inflation pressure using the pressure
gauge (1). The recommended inflation
pressure can be found on the Tyre and
Loading Information label.
The pressure gauge (1) may read higher
than the actual tyre pressure while the
compressor is on. Turn the compressor off
to get an accurate reading. The compres-
sor may be turned on/ off until the correct
pressure is reached.
If you inflate the tyre higher than the
recommended pressure you can adjust
the excess pressure by pressing the
pressure deflation button (4) until the
proper pressure reading is reached.
This option is only functional when using
the air only hose (6).
11. Press the on/off button (4) to turn the tyre
sealant and compressor kit off.
Be careful while handling the tyre seal-
ant and compressor kit as it could be
warm after usage.
12. Unplug the power plug (8) from the
accessory power outlet in the vehicle.
13. Disconnect the air only hose (6) from the
tyre valve stem, by turning it counterclock-
wise, and replace the tyre valve stem cap.
14. Replace the air only hose (6) and the
power plug (8) back in its original
location.
15. Place the equipment in the original
storage location in the vehicle.
The tyre sealant and compressor kit has an
accessory adapter located in a compartment
on the bottom of its housing that may be used
to inflate air mattresses, balls, etc.
Hide quick links:
Advertisement
Table of Contents
