Table of Contents
Advertisement
5–8 EMERGENCIES
12. Unplug the power plug (8) from the
accessory power outlet in the vehicle.
13. Turn the sealant/air hose (7) counterclock-
wise to remove it from the tyre valve stem.
14. Replace the tyre valve stem cap.
15. Replace the sealant/air hose (7), and the
power plug (8) back in their original
location.
16. If the flat tyre was able to inflate to the
recommended inflation pressure, remove
the maximum speed label from the seal-
ant canister (5) and place it in a highly
visible location.
Do not exceed the speed on this label until
the damaged tyre is repaired or replaced.
17. Return the equipment to its original
storage location in the vehicle.
18. Immediately drive the vehicle 8 km
(5 miles) to distribute the sealant in the
tyre.
19. Stop at a safe location and check the tyre
pressure. Refer to Steps 1 through 11 un-
der "Using the Tyre Sealant and Compres-
sor Kit without Sealant to Inflate a Tyre
(Not Punctured)."
If the tyre pressure has fallen more than
68 kPa (10 psi) below the recommended
inflation pressure, stop driving the vehicle.
The tyre is too severely damaged and the
tyre sealant cannot seal the tyre.
If the tyre pressure has not dropped more
than 68 kPa (10 psi) from the recom-
mended inflation pressure, inflate the tyre
to the recommended inflation pressure.
20. Wipe off any sealant from the wheel, tyre
or vehicle.
21. Dispose of the used sealant canister (5)
and sealant/air hose (7) assembly at a
local dealer or in accordance with local
regulations and practices.
22. Replace it with a new canister available
from your dealer.
23. After temporarily sealing a tyre using the
tyre sealant and compressor kit, take the
vehicle to an authorized dealer within a
161 km (100 miles) of driving to have the
tyre repaired or replaced.
Hide quick links:
Advertisement
Table of Contents
