Installing The Ir Blaster; Checking The Installation - Motorola DCP501 Installation Manual

E-2 Adding the IR Blaster Option

Installing the IR Blaster

To install the IR Blaster:
1
Fit the transmitter into the mounting bracket (refer to Figure E-1).
2
Plug the mini-pin connector into the
E-2).
Figure E-2
IR blaster installed
DCP501
VCR
3
Remove the adhesive tape cover from the mounting bracket.
4
Position the IR receiver off center of the VCR receiver and then press firmly attaching the
mounting bracket on the VCR. Be careful to route the wire so that it does not prevent
loading videotapes.

Checking the Installation

The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCP501. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCP501 Installation Manual
jack on the rear panel of the DCP501 (refer to Figure
IR
À LA PLUIE NI À L'HUM IDITE".
MODEL NO.: DCP 501